How to install single glass shower door?
Fitting instructions for glass shower Doors.
Mount the hinges on the glass door, remove the screws and cover plates from the hinges. Place the main body of the hinge in the glass cut‐out and attach with the allen screws supplied . Align the hinge and black gaskets in the cut‐out making sure it is centered up and down and that the edge of the plate is even with the edge of the glass and tighten with the allen key. Place 2 blue shims on each end of corner of the base to make a gap distance of 10mm for the bottom seal to work correctly against the shower tray or tiled floor. Plumb the door with a level using a pencil, mark the screw holes on the hinge. Remove the door so the holes can be drilled, then insert raw plugs (not supplied) and tap them in so they are flush with the wall. Hinges can be loosened slightly for any small adjustment then re-tightened with allen key. Open the door inwards/outwards to remove the shims from under the door then fit the knob or pull handle and finally the side seals and bottom sweep simply cut to size, the hinge side will be cut into 3 pieces to suit.